Cause Of Glashütte Watch Error

Glashütte mechanical watches sold on the market. Due to the structural characteristics of the mainspring, the material, the friction and fatigue between the coils, the change in the output torque from strong to weak, and the friction generated by the mainspring and gears during the transmission of the force distance, all will affect the accuracy of the clock.
The climate, regional environment, and location also affect the normal operation of the Glashütte clockwork. The current quartz clock overcomes the weakness of mechanical watches, uses the extremely stable high-frequency vibration of quartz crystals as the time reference, and divides the frequency by a frequency-dividing circuit to once per second, and then drives the gear through a micro-stepping motor or scanning , Pointer, indicating time, even so, because the quartz crystal used is affected by temperature changes, errors will occur, usually 15 seconds per day. This is allowed.
Why is the Glashütte mechanical watch not electronically accurate? What is the error? The daily error of the Glashütte quartz electronic watch is less than 0.5 seconds, which is a few tenths of the Glashütte mechanical watch. This is mainly due to the quartz in the quartz watch. The oscillator has a high and stable oscillation frequency. The principle of high frequency and accurate time is a principle found in the long-term study of how to improve the accuracy of timepieces. The higher the frequency of the oscillator, the more stable the oscillation, the stronger the anti-interference ability, and the more accurate the watch. Glashütte quartz electronic watch’s oscillation frequency is 32768Hz, which is 10,000 times higher than the frequency of 3Hz per second of ordinary fast-swing mechanical watches, so quartz electronic watches are much more accurate than Glashütte mechanical watches.
In addition, due to the structural problems of the mechanical Glashütte watch, due to the gravitational force of the earth, the horizontal and vertical positions will produce a disparity. The spring is tightened to loosened, the torque is unbalanced. The impact of vibration, etc., even if the mechanical watch raises some frequencies, it is impossible to reach the accuracy of the quartz electronic watch. Glashütte watches, which are always within minutes, do not exist. There is an error range for both mechanical and stone watches, and this range varies from country to country. Generally speaking, as long as the mechanical watch is full In the case of travel, the travel time is no more than 30 seconds per day, and the standard is basically up to 30 seconds. The quartz watch meets the standard when the battery is fully charged and the speed is not more than 0.5 seconds. Therefore, whether it is a Glashütte mechanical watch or a Glashütte quartz watch, as long as their errors are within the above two standard ranges, we can say that the watch is qualified to pass. On the contrary, it means that there is a problem when the Glashütte watch is gone, and it must be adjusted by the repair and maintenance department.